Part E - Section 2 - Development in Employment and Mixed Use Zones

2.1Introduction

2.1.1General Objectives

The general objectives of this Section of the DCP are to ensure that non-residential development in the E1 Local Centre, E2 Commercial Centre, E3 Productivity Support, MU1 Mixed Use zones and the SP2 Infrastructure zone where located wholly within existing employment centres:

  1. 01
    can meet the aims and employment targets as outlined in the State Government's Regional Plan and District Plan,
  2. 02
    is consistent with the principles contained within the Integrated Land Use and Transport Policy;
  3. 03
    provide various grades and sizes of commercial floorspace to accommodate a mix of business, service, high tech industry, retail and recreational uses,
  4. 04
    are designed to contribute positively to their surroundings and particularly to diversity, vitality, social engagement and 'a sense of place',
  5. 05
    provide active street frontages both during the day and night,
  6. 06
    are designed to mitigate against the extreme impacts of the sun, wind and rain,
  7. 07
    provide adequate natural light to buildings, public places and streets,
  8. 08
    creates safe and high quality urban environments through careful design of buildings and use of materials, and a well designed and maintained public domain,
  9. 09
    encourages the provision of adaptable office development which meets the requirements of new office technology and caters for variations in office layout and use,
  10. 010
    soften the highly urbanised landscape by introducing water and greenery,
  11. 011
    minimise stormwater runoff, maintain and improve stormwater quality and encourage recycling where possible, and
  12. 012
    contribute to attractive and well designed public open spaces to service increased population of the area.

2.1.2When does this section of the DCP apply?

This section of the DCP applies to:

  1. (a)
    development for any non-residential purpose on land zoned:
    1. (i)
      E1 Local Centre,
    2. (ii)
      E2 Commercial Centre,
    3. (iii)
      MU1 Mixed Use,
    4. (iv)
      E3 Productivity Support,
  2. (b)
    development for any non-residential purpose on land zoned SP2 Infrastructure, except where any adjacent or adjoining land is zoned:
    1. (i)
      R2 Low Density Residential,
    2. (ii)
      R3 Medium Density Residential,
    3. (iii)
      R4 High Density Residential, or
    4. (iv)
      C4 Environmental Living.

Where the subject land is zoned SP2 Infrastructure and any adjacent or adjoining land is zoned R2 Low Density Residential, R3 Medium Density Residential, R4 High Density Residential or C4 Environmental Living, development applications will be required to comply with Part E: Section 3 – Non-residential development in residential zones of the DCP.

If land zoned SP2 Infrastructure is located adjacent to one or more of the following zones:

  1. (a)
    E1 Local Centre,
  2. (b)
    E2 Commercial Centre,
  3. (c)
    MU1 Mixed Use,
  4. (d)
    E3 Productivity Support.

then the controls of the most restrictive zone will apply to the subject site. For example, if the subject site is located adjacent to land zoned E1 Local Centre and MU1 Mixed Use, then the provisions of the E1 Local Centre would apply.

This Section is applicable to mixed use developments incorporating components of both non-residential development and residential accommodation. For mixed use development, this Section applies to the non-residential component. The residential accommodation component of mixed use development is required to comply with the relevant requirements under Part E: Section 1 - Residential Development of the DCP.

2.2Function

The main financial and business activities are complemented by a variety of other supporting infrastructure, activities and services located in and around the area which are essential to its functioning as a place where people work, live and visit.

Diversity of people, environments and experiences encourages activity and contributes to the popularity of areas. Diversity attracts many users, extends the usefulness of the area and contributes to the sustainability of both community and environment.

2.2.1Diversity of activities, facilities, opportunities and services

Objectives
  1. O1
    To ensure a diversity of activities, facilities, opportunities and services is provided, including high grade business accommodation, community services, employment, entertainment, government agencies, health and welfare, recreation and retail.
  2. O2
    To ensure that streets are appropriately activated to encourage pedestrian use.
Provisions
  1. P1
    Non-residential buildings or components of buildings should incorporate a variety of different sized spaces that reflect a site's location in the commercial centre hierarchy (i.e. large floor plates should be provided in higher order centres with small floor plates in lower order centres).
  2. P2
    Consideration should be given to incorporating community and entertainment facilities within a development.
  3. P3
    A variety of uses should be provided at street level, which contributes positively to economic and social vitality.
  4. P4
    Avoid blank walls that face streets and laneways at the ground level.
  5. P5
    Enhance the amenity of the public domain to meet the needs of the workforce, residents and visitors.
  6. P6
    Mixed use developments should have the non-residential uses located at least on the ground floor, and any residential uses located on floors above the non-residential uses.

2.2.2Design of tourist and visitor accommodation

Objectives
  1. O1
    To ensure that hotel or motel accommodation and serviced apartments are not used or converted for permanent residential accommodation.
  2. O2
    To minimise impacts on the operation of other uses, where the short term visitor accommodation is provided within a mixed use development.
Provisions
  1. P1
    No more than 50% of rooms to hotel or motel accommodation must be provided with kitchens or kitchenettes.
  2. P2
    Rooms to hotel or motel accommodation must be provided in accordance with the dimensions indicated in Table E-2.1.
TABLE E-2.1 - Minimum and maximum room sizes
Number of personsMinimum SizeMaximum Size
110.5m²27m²
216m²27m²
321.5m²27m²
4 (max)27m²27m²
  1. P3
    All tourist and visitor accommodation developments must provide common facilities such as conference rooms, restaurants and bars.
  2. P4
    Balconies to hotel or motel accommodation rooms are not permitted.